Equipment
Forum Thread of the Day: “How do you go about choosing a 3-wood?”
Today’s Forum Thread of the Day comes from kcd38 who opens the discussion regarding WRXers approach to choosing a 3-wood. Our members discuss what they want from a 3-wood and how their driver often plays a pivotal role in deciding what they need and want from their 3-metal.
Here are a few posts from the thread, but make sure to check out the entire discussion and have your say at the link below.
- HappyGilmore22: “I bought a 3-wood based on whichever low spin combo I could get the best value out of because I’ve tested ten 3-woods and can’t decide between any of them. Went with TS3 and stock shaft in an 80-gram weight class with x-flex, added bonus they fit for the proper swing weight I like. The M5 was my favorite, but with the correct shaft and specs it would have run me over $700, and I wasn’t about to be paying that for a 3-wood that I rarely hit when my $300 one is just as good.
- Yuck: “3-woods are tough to get one you like under all conditions. I have had 3 of them over the last 40+ years. A Macgregor persimmon from the late 70s till early 90’s. A TM burner bubble tour spoon from the early 90, till 2004. And a TEE CB 2, still in my bag for the last 15 years.”
- RichieHunt: “I go to a fitter that has a lot of club head options. I find it difficult to get a good 3-wood because they are not easy to hit well and they usually either go long, but suck to hit off the deck, or they hit off the deck well, but don’t go as long as I would like. So that’s why I try to get as many head options as I can to find the best one for me. Then I go to Fujikura and get fitted for a shaft. I also find that 3-wood heads wear down much more quickly than driver heads. So you finally get a head you like and after a short while it’s not performing like it once did, and the new model heads come in.”
- AG12: “I’ve found for me that when trying to find the right amount of spin and height I got with a mid-low launch/low spin shaft in the brand’s more forgiving head if they have two (M4 over M3, TS2 over TS3, Flash over Sub Zero) and it seems to be a good recipe for launch, forgiveness and stopping power.”
Entire Thread: “How do you go about choosing a 3-wood?”
- LIKE6
- LEGIT0
- WOW1
- LOL3
- IDHT2
- FLOP1
- OB0
- SHANK6
Whats in the Bag
Taylor Pendrith’s winning WITB: 2024 CJ Cup Byron Nelson
Driver: Ping G430 LST (9 degrees) Buy here.
Shaft: Accra TZ Six ST
3-wood: Ping G430 Max (15 degrees) Buy here.
Shaft: Project X HZRDUS Smoke Green 80 6.5 TX
7-wood: Ping G425 Max (20.5 degrees) Buy here.
Shaft: Project X HZRDUS Smoke Green 90 6.5 TX
Irons: Srixon ZX (2, 3) Buy here, Srixon ZX7 Mk II (4-9) Buy here.
Shafts: Project X HZRDUS Smoke Black 6.5 90, 6.5 100 (2-3), True Temper Dynamic Gold Tour Issue X100
Wedges: Cleveland RTX 6 Tour Rack (46-10 Mid, 52-10 Mid, 56-10 Mid, 60-9 Full) Buy here.
Shafts: True Temper Dynamic Gold Tour Issue X100
Putter: Odyssey Jailbird Versa Buy here.
Grip: SuperStroke Zenergy Flatso 1.0
Grips: Golf Pride MCC
The winning WITB is presented by 2nd Swing Golf. 2nd Swing has more than 100,000 new and pre-swung golf clubs available in six store locations and online. Check them out here.
- LIKE15
- LEGIT0
- WOW0
- LOL2
- IDHT0
- FLOP0
- OB0
- SHANK0
Whats in the Bag
Ben Kohles WITB 2024 (May)
Driver: Titleist TSR3 (9 degrees, D1 SureFit setting)
Shaft: Fujikura Ventus Blue 6 X
3-wood: TaylorMade Stealth Plus (15 degrees)
Shaft: Fujikura Ventus Blue 8 X
Hybrid: Titleist TSR3 (19 degrees, D1 SureFit setting)
Shaft: Fujikura Ventus Blue HB 9 X
Irons: Titleist T200 (4, 5), Titleist 620 CB (6-9)
Shafts: Project X 6.0
Wedges: Titleist Vokey Design SM10 (46-10F, 50-12F, 54-12D, 60)
Shafts: Project X 6.0
Putter: Scotty Cameron P5 prototype
Grips: Golf Pride Tour Velvet
Ball: Titleist Pro V1
Check out more in-hand photos of Ben Kohles’ clubs in the forums.
- LIKE11
- LEGIT0
- WOW0
- LOL3
- IDHT0
- FLOP0
- OB0
- SHANK0
Whats in the Bag
Kris Kim WITB 2024 (May)
- Kris Kim what’s in the bag accurate as of the CJ Cup Byron Nelson. More photos from the event here.
Driver: TaylorMade Qi10 (9 degrees @7)
Shaft: Mitsubishi Tensei 1K White 60 TX
3-wood: TaylorMade Qi10 Tour (15 degrees @13.5)
Shaft: Mitsubishi Diamana WB 73 TX
Irons: TaylorMade P770 (2, 4), TaylorMade P7MB (5-PW)
Shafts: Mitsubishi Tensei 1K White 80 TX (2), Nippon N.S. Pro Modus3 Tour 120 X
Wedges: TaylorMade MG4 (50-09SB, 56-12SB, 60-11TW)
Shafts: Nippon N.S. Pro Modus3 WV 125
Putter: TaylorMade Spider Tour
Grips: Golf Pride Tour Velvet Cord
Check out more in-hand photos of Kris Kim’s equipment here.
View this post on Instagram
- LIKE4
- LEGIT0
- WOW0
- LOL0
- IDHT0
- FLOP0
- OB0
- SHANK0
-
19th Hole2 weeks ago
Justin Thomas on the equipment choice of Scottie Scheffler that he thinks is ‘weird’
-
19th Hole2 weeks ago
‘Absolutely crazy’ – Major champ lays into Patrick Cantlay over his decision on final hole of RBC Heritage
-
19th Hole3 weeks ago
Report: LIV Golf identifies latest star name they hope to sign to breakaway tour
-
19th Hole3 weeks ago
Neal Shipley presser ends in awkward fashion after reporter claims Tiger handed him note on 8th fairway
-
19th Hole3 weeks ago
Brandel Chamblee has ‘no doubt’ who started the McIlroy/LIV rumor and why
-
19th Hole1 week ago
LET pro gives detailed financial breakdown of first week on tour…and the net result may shock you
-
Equipment3 weeks ago
Jason Day on his recent switch into Srixon ZX5 and ZX7 Mk II irons
-
19th Hole5 days ago
Gary Player claims this is what ‘completely ruined’ Tiger Woods’ career
Christopher Hansen
Sep 1, 2019 at 7:57 pm
Focus on the shaft. Modern 3-wood head design is not that different from one manufacturer to the next. Once you find the right shaft, make your big investment in the shaft and swap heads as needed.
s
Jul 13, 2019 at 5:30 pm
Spotted someone hitting MP-001 at the range. The head looked beautiful. Found a brand new one at my local pro shop for $120. Could hit it with my eyes closed. That was back in 2007. Still in my bag.
Distance Compression Dude
Jul 13, 2019 at 2:08 pm
Does it produce my desired trajectory?
Does it make the ball spin enough?
Does it neutralize my misses?
Is it easy to hit off the deck?
Is it easy to shape the ball flight with it?
If the answer is “yes” to all of those, then I found my 3 wood.
But, alas, I haven’t found the right one yet.