Connect with us

Equipment

Spotted: Piretti Golf No-Torque putters

Published

on

Piretti isn’t a name that every golfer knows, but they have been making high-quality, milled putters since 2008. Piretti putters have seen some use on the PGA Tour when Tony Finau used a couple of different models for a few years. Piretti crafts all of its putters right here in the United States, with its headquarters located in Spring, Texas. We spotted some new No-Torque putters out on the practice green at the 2025 Texas Houston Open this week.

Savona 2.5

This looks to be a smaller mallet with wings that run down the outside of the putter. These wings are then connected at the back with a flat bar, leaving a rectangular hole in the middle of the putter. A short plumbers neck is attached backwards on the topline to get the shaft axis going through the center of the putter, behind the face. This design gives it the No-Torque balance, where the face will stay pointed at the target throughout the stroke. Piretti keeps it simple with a frosted silver finish and single black sight line on the flange of the putter. A traditional fly milling is done on the face with the Piretti logo over on the heel.

Farrara 2.5

Piretti used the same short plumbers neck on the blade version No-Torque putter. The body of the putter looks like an Anser/Newport with its soft, rounded bumpers flanking the rear cavity. Again they used a simple sight line on the flange for alignment while the sole has just the putter name and “No-Torque” milled into it. Like its mallet sibling, a medium depth face milling is done to give the putter a soft feel and sound with the Piretti logo.

I have been an employee at GolfWRX since 2016. In that time I have been helping create content on GolfWRX Radio, GolfWRX YouTube, as well as writing for the front page. Self-proclaimed gear junkie who loves all sorts of golf equipment as well as building golf clubs!

Click to comment

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Equipment

Interesting clubs at top of bag – GolfWRXers discuss

Published

on

In our forums, users are talking about top of bag setups that are non-traditional or thought-provoking in some way. Original poster @SuperSpurs106 inquired about other members who might use unorthodox set-ups to help with gapping issues or weak spots.

They wrote:

“I currently have a PING G430 driver, TM Qi35 3W and a TM Qi4D 7W. Driver and 7W are fine but can’t get on with my 3W and have always struggling with this club over the years. Thinking of adding a 2H which I know would look odd. Just wondering if anyone else had a weird set up at the top of their bag?”

Our members in the forum have offered up their thoughts and personal experiences with non-traditional top of bag set-ups, and their reasoning for thinking outside of the box to begin with. Here are a few posts from the thread, but make sure to check out the entire discussion and have your say at the link below.

  • BowMain42: “Don’t worry about what “looks” odd. If the club does what you need it to do, it’s the right club.”
  • scooterhd2: “I cant hit 3 woods either. Thats why I roll with a unicorn XL Hibore 2 wood. 400 cc head at 16 degrees of loft and its just a monster 3 wood off the tee. Off the deck, we are playing the f6 baffler. 5 wood at 41.75 inches and its easy to control.”
  • phizzy30: “I had driver, 3 metal, 2/4 hybrid once upon a time as a higher ss player. 4 hybrid is gone and in place is a driving iron nowadays. I don’t think what you’re proposing is weird in anyway, however the yardage gap might be glaringly huge between driver and 2 hybrid. What is it about your 3 metal that has got you all messed up? You could always go 4 metal with shorter shaft and see if that works.”

Entire Thread: “Interesting clubs at top of bag”

If you aren’t a member, join us in the GolfWRX forums today!

Continue Reading

Equipment

Members of the Mini Driver Club – GolfWRXers discuss

Published

on

In our forums, one user has gone searching for fellow users of a mini driver. In a post, @TightFade asked for other mini driver users to chime in with their weapon of choice, the reason for employing a mini, and what club follows it in the bag.

@TightFade asked:

“What mini are you playing? What spot in the bag did it take over? What’s the next club after it? For me: Elyte mini 13.5. Replacing 3w. Next up club looks like it’ll be 5w.”

Our members in the forum have been sharing their own bag setups featuring the mini driver, and the various reasons they purchased one in the first place. Here are a few posts from the thread, but make sure to check out the entire discussion and have your say at the link below.

  • RCGA: “Ping G430 Max 12* ‘Thriver.’ Next club is a 4w and 2i (I play a weird course).”
  • JMB3: “R7 at 12.75 with Diamana BB 63s. 3w replacement. Next Club: Elyte Ti 5w at 17*.”
  • ColdOkieGolf: “R7 15.5 turned down to 13.5 It replaces the 3w. I found it surprisingly easy to hit off the deck, and it’s very rare that I need or want to hit something beyond 250 from the fairway, so next club is my 7w.”
  • ChaosTheory: “I’m sub-90 MPH with driver. But I’m able to hit DOD. I have been wanting something like the R7 15.5, so I just ordered one. I have a spot in the bag so nothing has to go. But I could see it replacing my trusty 4 wood, which I never use for approach shots. Just tee shots and lay ups. If I drop the 4 wood, I will turn my 7 wood down to ~20 degrees and will have good gaps. I recently tried a thriver build: 12 degree driver turned to 14, with a heavier 44 inch shaft and added head weight. I hit it great. Very accurate and not overly high, but the problem was that it sometimes went as far as a typical drive. And that’s not what I needed. So I will probably turn the 15.5 up to 16.5 or even 17.5. It’s all theoretical at this point. ?”

Entire Thread: “Members of the Mini Driver Club…Check In.”

If you aren’t a member, join us in the GolfWRX forums today!

Continue Reading

Whats in the Bag

Chris Gotterup WITB 2026 (June)

Published

on

  • Chris Gotterup had >14 clubs in his bag when photographed prior to the Memorial Tournament.

Drivers: TaylorMade Qi4D (8 degrees), Ping G440 LST (9 degrees @8), Ping G440 LST (7.5 degrees)
Shafts: Project X HZRDUS Smoke Grey 6.5 TX 70 g, Project X HZRDUS T1100 Handcrafted 6.5 TX 70 g, Project X HZRDUS Smoke Grey 6.5 TX 70 g

Mini driver: TaylorMade BRNR (13.5 degrees)
Shaft: Project X HZRDUS Black TX 80 g

5-wood: TaylorMade Qi4D (18 degrees)
Shaft: Mitsubishi Chemical Diamana WB Wood Shaft 83 TX

7-wood: TaylorMade Qi4D (21 degrees)
Shaft: Mitsubishi Diamana WB Wood Shaft 83 TX

Irons: TaylorMade P770 (3), Bridgestone Tour B 220 MB (4-9)
Shafts: KBS C-Taper 130 X

Wedges: TaylorMade MG5 (46, 52, 56, 60)
Shafts: KBS C-Taper 130 X, True Temper Dynamic Gold Tour Issue X100

Putter: TaylorMade Spider X Tour
Grip: SuperStroke Zenergy Pistol 2.0

Grips: Golf Pride Z Grip Cord

Ball: Bridgestone Tour B X Mindset

Check out more in-hand photos of Chris Gotterup’s clubs here.

Continue Reading

Announcement

Our Privacy Policy and Terms of Use have been updated as of January 29th, 2026. Please review the updated policies here Privacy Policy | Terms of Use. By continuing to use our site after January 29th, 2026, you agree to the changes.

WITB

Facebook

Trending