Connect with us

Equipment

Forum Thread of the Day: “I think my 3-wood needs to go…but now what?”

Published

on

Today’s Forum Thread of the Day comes from Little Ned who is struggling with the 3-wood he had fitted for him and is looking for suggestions on what he should do now from fellow members. Little Ned only uses his 3-wood once or twice a round and feels like he may be wasting a spot in his bag, our members dish out their best advice on how he could utilize the club more effectively, while also giving alternative options.

Here are a few posts from the thread, but make sure to check out the entire discussion and have your say at the link below.

  • golfingfanatic: “I replaced my 3-wood with a 4-wood, and the difference has been remarkable. I feel like the shorter shaft, and the additional loft helps me a lot off the deck.”
  • dubbelbogey: “A quick and easy experiment would be to see if choking up on your 3w an inch or even an inch and a half makes a difference in your reliability of getting a clean(er) strike. If so, that’ll tell you something useful. It could be as simple as cutting the shaft (and maybe adding a little lead tape, if you’re worried about swing weight – to a lot of golfers it’s a minor factor) or steer you towards another shorter club, e.g. 4/5w or 2h. I do think the relatively small clubface and relatively longer length of a typical 3w are what makes them problematic for many golfers.”
  • reider69: “I just dumped my 3-wood for a 16 degree 2H. On my best hit I may get an extra 15 yards from the 3-wood, but so far I have hit over 10 shots on course with 2H, and all of them were in play and long enough. I can’t believe I didn’t do this sooner.”
  • ohioglfer: “I was inconsistent with 3-wood on fairways until I got a Ping G. Not a strong 3W at 16 degrees, but manageable off the deck most of the time. This improved even more when adjusted to 17 degrees, effectively making it a 4W. Overall, I’m pretty happy with it.”

Entire Thread: “I think my 3-wood needs to go…but now what?”

 

Your Reaction?
  • 37
  • LEGIT3
  • WOW1
  • LOL1
  • IDHT0
  • FLOP2
  • OB0
  • SHANK3

Gianni is the Managing Editor at GolfWRX. He can be contacted at [email protected].

5 Comments

5 Comments

  1. ~j~

    Apr 30, 2019 at 10:51 am

    All. I cannot state this loud enough, without using all CAPS OF COURSE.

    I’ve hated 3w’s my whole golfing life. Never had one that consistently worked well for all my funky over the years injuries and swings.

    Just after Xmas this year, picked up a Cobra F8+ model of a 4/5w, and set it at 16.5* (A typical 3w HL). I smoke this thing 80-90% of the time 250y+, whereas with my previous 3w (TM Aeroburner black, HL), I’d get what I wanted maybe 3-4 times out of 10.

    The 4/5w, F8+ is 2-3 inches shorter than a normal 3w, and has the feel and versatility of my favoriate hybrid or greenside lob wedge.

    If you generally hate 3w’s, go try this Cobra F8+ 4/5w combo.

  2. Earnie

    Apr 27, 2019 at 6:38 pm

    Tour Edge Exotics Period!

  3. Rick

    Apr 27, 2019 at 10:03 am

    I use a 4 wood with a 3 wood length shaft. When my swing is off a little, I just choke down on the shaft. Hit some good shots, get my confidence back.

  4. Mike

    Apr 27, 2019 at 7:08 am

    I have a strong 3-W in my bag. I can hit it off the deck, but since the lies on my course usually aren’t spectacular, I found that hitting my 3-H (@ 17 deg) instead gives me better overall results. I agree w/ one of the comments above in that when I do “catch” it, I am about 15 yds longer than my best 3H. But as a mid-handicapper, how often do I really “catch” it? My course does have a short par 4 & a long par 3 which is where that 3-W is my go-to club, so I do have a reason to keep it in my bag. Besides, what could I replace it with? As stated, my 3H is 17 deg & already carry a lob wedge?

  5. Q

    Apr 26, 2019 at 2:26 pm

    Quit golf

Leave a Reply

Cancel reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Whats in the Bag

Steve Stricker WITB 2024 (April)

Published

on

Driver: Titleist TSR3 (9 degrees, C4 SureFit setting)
Shaft: Fujikura Motore Speeder VC 7.2 X

3-wood: Titleist 915F (13.5 degrees)
Shaft: Mitsubishi Tensei CK Pro White 80 TX

Hybrid: Titleist 816 H1 (17 degrees)
Shaft: Fujikura Motore Speeder VC 9.2 X

Irons: Titleist T200 (3, 4), Titleist T100 (5-9)
Shafts: Project X 6.5

Wedges: Titleist Vokey SM8 (46-10F @55), Titleist Vokey SM10 (54-10S @53), Titleist Vokey SM4 (60 @59)
Shafts: True Temper Dynamic Gold X100 w/Sensicore

Putter: Odyssey White Hot No. 2

Ball: Titleist Pro V1x

Grips: Golf Pride Tour Velvet Grip Rite

Check out more in-hand photos of Steve Stricker’s clubs here.

Your Reaction?
  • 27
  • LEGIT2
  • WOW0
  • LOL1
  • IDHT1
  • FLOP0
  • OB0
  • SHANK1

Continue Reading

Whats in the Bag

Alex Fitzpatrick WITB 2024 (April)

Published

on

  • Alex Fitzpatrick what’s in the bag accurate as of the Zurich Classic. 

Driver: Ping G430 LST (10.5 degrees)
Shaft: Fujikura Ventus Black 6 X

3-wood: TaylorMade Qi10 (15 degrees)
Shaft: Fujikura Ventus TR Black 7 X

Hybrid: Ping G430 (19 degrees)
Shaft: Fujikura Ventus Black HB 10 TX

Irons: Ping iCrossover (2), Titleist T100 (4-PW)
Shafts: Fujikura Ventus Black HB 9 TX (2), Nippon N.S. Pro Modus 3 Tour 120 X (4-9)

Wedges: Titleist Vokey Design SM10 (50-12F, 56-12D, 60-08M)
Shafts: Nippon N.S. Pro Modus 3 Tour 120 X

Putter: Bettinardi SS16 Dass

Grips: Golf Pride MCC

Check out more in-hand photos of Alex Fitzpatrick’s clubs here.

Your Reaction?
  • 12
  • LEGIT0
  • WOW1
  • LOL1
  • IDHT1
  • FLOP0
  • OB0
  • SHANK0

Continue Reading

Equipment

What’s the perfect mini-driver/shaft combo? – GolfWRXers discuss

Published

on

In our forums, our members have been discussing Mini-Drivers and accompanying shafts. WRXer ‘JamesFisher1990’ is about to purchase a BRNR Mini and is torn on what shaft weight to use, and our members have been sharing their thoughts and set ups in our forum.

Here are a few posts from the thread, but make sure to check out the entire discussion and have your say at the link below.

  • PARETO: “New BRNR at 13.5. Took it over to TXG (Club Champ but TXG will always rule) in Calgary for a fit. Took the head down to 12, stuck in a Graphite Design AD at 3 wood length and 60g. Presto- numbers that rivaled my G430Max but with waaaaay tighter dispersion. Win.”
  • driveandputtmachine: “Still playing a MIni 300.  The head was only 208, so I ordered a heavier weight and play it at 3 wood length.  I am playing a Ventus Red 70.   I play 70 grams in my fairways.  I use it mainly to hit draws off the tee.  When I combine me, a driver, and trying to hit a draw it does not work out well most of the time.  So the MIni is for that. As an aside, I have not hit the newest BRNR, but the previous model wasn’t great off the deck.  The 300 Mini is very good off the deck.”
  • JAM01: “Ok, just put the BRNR in the bag along side a QI10 max and a QI10 3 wood. A load of top end redundancy. But, I have several holes at my two home courses where the flight and accuracy of the mini driver helps immensely. Mine is stock Proforce 65 at 13.5, I could see a heavier shaft, but to normal flex, as a nice alternative.”

Entire Thread: “What’s the perfect Mini-Driver/Shaft combo? – GolfWRXers discuss”

Your Reaction?
  • 6
  • LEGIT1
  • WOW0
  • LOL0
  • IDHT2
  • FLOP1
  • OB0
  • SHANK7

Continue Reading

WITB

Facebook

Trending