When you hear the Diamana name, you immediately think of the current, or legendary, wood shafts that have been winning on tour for 20 years. However, few die-hard club junkies would think of a Diamana putter shaft, but Mitsubishi Golf is always pushing the limits and are delivering just that.

Graphite putter shafts have been a growing segment in the equipment world with companies noticing that they can create ultra-stable putter shafts that keep the putter on target through the stroke. Graphite also gives engineers the ability to adjust the performance, stiffness, and weight so golfers have more options to dial in the feel of their putter.

To get the full, in-depth review of the Mitsubishi Diamana P105 putter shaft check out the Club Junkie podcast on all podcast platforms or on YouTube.

Out of the box, the Mitsubishi Diamana P105 might be the best-looking putter shafts I have ever seen. The carbon weave at a 45-degree angle just reflects the light well, and then the shaft fades down into black near the tip section. A Diamana staple, the flowerband, is located just a little way under the grip but high enough up where it isn’t a distraction when looking down at the putter.

I installed the P105 into the new Bettinardi BB1 Wide putter, and it looked perfect with Bettinardi’s diamond black finish. The duo is definitely one of the meanest-looking combos in my rotation of putters. Both the P105 and the P135 are built using premium carbon fiber with a low amount of resin for added touch and feel. Mitsubishi utilizes 24t and high-strength intermediate modulus carbon fiber to build up the strength and stability, while the visible 6K woven fabric helps reduce torque.

The first question I get with this shaft is about the 108-gram weight. People areasking if it is too light. Honestly, if the shaft had no markings on it, I don’t know if I could tell that is was lighter than a traditional steel shaft. Now the head might feel a touch heavier and the balance of the putter slightly lower but I didn’t really notice the overall static weight of the putter being too light.

The P135 shaft comes in two flexes, 1.0 and the stiffer 2.0, but the P105 only comes in the 1.0 flex. To me, the P105 might be one of the softer graphite putter shafts I have tried and you can see a little bit of wiggle when you waggle the putter. Some players like a slightly softer putter shaft for additional feel and it can work with the tempo of their putting stroke.

On the course, the Diamana P105 offers the consistent stability that you expect from aftermarket putter shafts. On short putts the shaft stays right with your stroke and the putter head is always where you expect it, aligned with your hands and grip. Shorter strokes don’t show off the slightly softer flex of the shaft and you experience the added control of the low torque design.

When you hit longer lag putts you can notice a little flex in the shaft but the head never waivers from being square to your target. Speed control didn’t change at all from the traditional steel shaft in the Bettinardi to the Diamana. On the practice green hitting multiple putts at the same hole, it was easy to feel like you hit the correct speed and then see the results. Balls ended in the same area, as well as my skill would allow, and I never hit a ball the felt like it came up far shorter or longer than I expected it too.

Feel is such a subjective thing and each golfer is going to react differently to it. For me the Diamana had a slightly firmer feel than some of the other graphite shafts out there. If you are looking for responsiveness out of your putter shaft, the Diamana offers just that. To me the Diamana has more of a steel feel to it when it comes to getting the vibration from impact to your hands. You will feel exactly where you made contact on the face, giving you the ability to adjust your stroke and get back to making more center contact. I have found that most other graphite shafts mute the vibration a little and offer a softer feel, but the Diamana keeps the feel and sound exactly as they are.

Mitsubishi’s Diamana putter shaft is a great option for the golfer who wants to add some stability and consistency to their stroke without sacrificing feel. Players who love a specific putter face material or milling pattern to enhance their feel will be excited to not lose that with the upgrade to the Diamana.

Originally, Project X was known for low-spin steel iron shafts. However, the company might now be known for wood shafts. Denali is the newest line of graphite shafts from Project X. With the Denali line, the company focuses on feel as well as performance.

There are two profiles in the Denali line, Blue and Black, to fit different launch windows. Denali Blue is the mid-launch and mid-spin profile for players who are looking for a little added launch and Denali Black is designed for low-launch and low-spin. Both models are going to offer you a smooth feel and accuracy.

For a full in-depth review check out the Club Junkie podcast on all podcast streaming platforms and on YouTube.

Project X Denali Blue

I typically fit better into mid-launch shafts, as I don’t hit a very high ball so the Denali Blue was the model I was more excited to try. Out of the box, the shaft looks great and from a distance, it is almost hard to tell the dark blue from the Denali Black. With a logo down install of the shaft, you don’t have anything to distract your eyes, just a clean look with the transition from the white and silver handle section to the dark navy mid and tip.

Out on the course, the Blue offers a very smooth feel that gives you a good kick at impact. The shaft loads easily and you can feel the slightly softer handle section compared to the HZRDUS lineup. This gives the shaft a really good feel of it loading on the transition to the downswing, and as your hands get to impact, the Denali Blue keeps going for a nice, strong kick.

Denali Blue is easy to square up at impact and even turn over to hit it straight or just little draws and most of the flex of the shaft feels like it happens right around where the paint changes from silver to blue. The Blue launches easily and produces what I consider a true mid-flight with the driver. While it is listed as mid-spin, I never noticed any type of rise in my drives. Drives that I didn’t hit perfectly were met with good stability and a ball that stayed online well.

Project X Denali Black

When you hold the Denali Black in your hands you can tell it is a more stout shaft compared to its Blue sibling by just trying to bend it. While the handle feels close to the Blue in terms of stiffness, you can tell the tip is much stiffer when you swing it.

Denali Black definitely takes a little more power to load it but the shaft is still smooth and doesn’t give you any harsh vibrations. Where the Blue kicks hard at impact, the Black holds on a little and feels like keeps you in control even on swings that you try and put a little extra effort into. The stiff tip section also makes it a little harder to square up at impact and for some players could take away a little of the draw from their shot.

Launch is lower and more penetrating compared to the Blue and produces a boring, flat trajectory. Shots into the wind don’t rise or spin up, proving that the spin stays down. Like its mid-launch sibling, the Black is very stable and mishits and keeps the ball on a straighter line. Shots low off the face don’t get very high up in the air, but the low spin properties get the ball out there farther than you would expect. For being such a stout shaft, the feel is very good, and the Denali Black does keep harsh vibrations from your hands.

Overall the Project X Denali Blue and Black are great additions to the line of popular wood shafts. If you are looking for good feel and solid performance the Denali line is worth trying out with your swing. Choose Blue for mid-launch and mid-spin or Black for lower launch and low spin.

Bettinardi has long been known as one of the best putter manufacturers in golf. The BB line is considered the company’s flagship. This year, Bettinardi took more input from the tour in order to optimize CG placements and refine the feel in the lineup. To optimize the CG and ensure that the sweet sport is in the correct location, Bettinardi engineers reshaped the shoulders and bumpers on the back of the head for better weight placement. The face also features a brand new Perpetual Flymill milling that enhances feel and feedback as well as gets the ball rolling more consistently. You can check out all of the details on the 2024 Bettinardi BB line of putters in our launch report. For a full review check out the Club Junkie podcast on all platforms or on YouTube below.

I have been using a Bettinardi BB8 Wide for the past two years, both previous generations, and really loved those putters. They were the first blade putters I have actually gamed in well over 10 years, so you know I was excited to see the 2024 BB lineup.

The BB1 Wide jumped out to me immediately, because it is similar to the BB8 Wide, just a little softer and with more rounded edges. Out of the box, the BB1 Wide looks great, and I think the new Black Pearl PVD finish has a slight shine to it that looks a little nicer and more high quality than the matte grey from the last generation. The gloss black stepless shaft and bright blue Lamkin grip are solid editions to the whole package and give the putter a little glitz that doesn’t distract. Finally, Bettinardi updated the BB covers to magnetic closure, and I am way too happy about that!

Out on the green, the BB1 Wide frames the ball well and you can easily see that it has a shorter heel-to-toe measurement than the BB8 Wide. From face to back the putter is wide, but I think the stubbiness of the head makes it look a touch wider than it really is. The look from address also greets you with a softer and more rounded look from the bumpers and overall shape of the head. As you would expect the flange is longer and includes a single site line for alignment. I like this setup as a single, longer, site line tends to be what I line up the best. A thicker topline is slightly rolled for a softer and thinner look that blends in well with the profile of this putter head. If you like the larger mallets that have been trending lately then I think you will enjoy looking down at the BB1 Wide.

On the course and the putting green, the Bettinardi BB1 Wide offers a great soft feel at impact, softer to me than last year’s BB8 Wide. Bettinardi’s Perpetual Fly Mill face has deeper grooves that provide this softer feel while still putting a nice roll on the ball. The greens up here in the north are still long and bumpy, but the BB1 Wide provided as smooth of a roll as it could under the conditions. Some playing partners were dealing with big hops and jumps in the first foot of their putts, but I never had that problem with the BB1 Wide. The initial roll limited the hop and skip more than I expected, and I felt like it started the ball on line very well. Aiming the putter was simple and easy as I had the same single site line on my previous putter.

The sole of the BB1 Wide is a little unique as it has a sound slot that runs the length of the cavity from heel to toe. We don’t see a lot of sound slots on retail putters but they are used to fine-tune the sound of a putter at impact. The use of the sound slot on the BB1 Wide definitely increases the audible sound at impact and gives it a slightly more metallic sound. I was a little worried that the sound would have too much “ting” to it or be offensively loud, but I was impressed that it was much more dialed down. Feel off the face was soft, definitely softer than the previous BB line. Now while that softer face is great, it does reduce a little of the feedback on where you struck the shot. You can tell the misses are there but they are a little softer than you would expect from a fully milled putter.

Forgivness with this putter is pretty good, and it will allow you to get away with less-than-perfect strokes. The amount of mass out on the toe and heel make the putter much more stable than a lot of blades. While it isn’t high mallet MOI stable the putter will show you that shots off the toe or heel will stay online well and come to rest right next to the hole. Distance control is precise and you won’t be stunned by a ball that jumps off the face with too much speed or the opposite. Putts on the putting green from the same spot just consistently toll to the same finish line, if they don’t drop into the cup.

Ultimately, a new finish, face milling, and design keep things fresh and high-performance but in a very classic package. Bettinardi did a great job mixing those things to keep the traditionalist and the gear junkies both happy. While the lineup doesn’t feature a massive amount of head shapes, it nails some core designs and should be a big hit for Bettinardi.