Connect with us

Equipment

Tiger Woods spotted testing new “TaylorMade GAPR LO” driving iron at Carnoustie

Published

on

Ahead of the 2018 Open Championship at Carnoustie, Tiger Woods was spotted by social media testing a “TaylorMade GAPR LO” driving iron.

The GAPR LO has been on our radar here at GolfWRX with photos recently popping up on our forums; our Two Guys Talking Golf podcast investigated the photos extensively. Follow the links above to learn more about the iron.

Below are the photos from social media that suggest Tiger is testing the TaylorMade GAPR iron.

Based on the photo above, it appears Tiger is going with a Mitsubishi Tensei Orange shaft, at least in his early-week testing. We’ll follow this closely as the week continues.

Do you think Tiger will use the new iron during competition at the Open Championship?

Join the discussion about the GAPR LO iron in our forums.

Your Reaction?
  • 83
  • LEGIT8
  • WOW2
  • LOL7
  • IDHT1
  • FLOP1
  • OB1
  • SHANK7

He played on the Hawaii Pacific University Men's Golf team and earned a Masters degree in Communications. He also played college golf at Rutgers University, where he graduated with a Bachelor of Arts in Journalism.

3 Comments

3 Comments

  1. Curt

    Jul 17, 2018 at 10:08 am

    TW finally embracing all that technology has to offer. He knew he’d better for this last run.

  2. Man

    Jul 16, 2018 at 12:48 pm

    Will it be parallel or taper tip? Did they shave that shaft down for TW or did they make a taper tip version specifically for him?

  3. Lm

    Jul 15, 2018 at 10:01 pm

    It has 6 degrees of loft

Leave a Reply

Cancel reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Equipment

Spotted: Tony Finau’s driver shaft change at the 2024 Texas Children’s Houston Open

Published

on

Tony Finau has always been known as one of the longest players on the PGA Tour, but he has recently been working on adding a little more distance. Last year, Finau averaged 118.3 mph club head speed and 178.08 mph ball speed, all while playing a Mitsubishi Diamana D+ Limited 70 TX driver shaft. This year, he has increased his club head speed to 123.93 mph and his ball speed to 183.32 mph.

However, Finau’s overall distance has decreased by two yards in that time. From a fitting perspective, something was amiss. We asked Tony about the shaft change at the Texas Children’s Hospital Open.

“[I’m seeing] better numbers with the spin. My driver’s been a little high spin for me over the last month or so, and so I just figured it was time to probably check out the equipment,” Finau said. “And it definitely showed me that I was using a shaft that’s maybe a little too tip-stiff for me, the way I load the club now. [I’m seeing] better numbers with the spin.”

Finau switched from the Mitsubishi Diamana D+ Limited 70 TX into the Diamana GT 70 TX. The newer Diamana GT has a slightly different profile than the D+ Limited with the stiffest handle section in the Diamana lineup. The mid sections between the two are similar stiffness but the tip is just slightly stiffer in the Diamana GT. Both shafts are within one gram of each other in the 70 TX. The torque rating on the GT is 0.1 higher than the D+Limited’s 2.7 measurement.

Mitsubishi lists the Diamana GT as a shaft between the mid-launching Diamana TB and the new low-launch Diamana WB shafts. For most players, it would be considered a mid/low launch and low-spin shaft option. Mitsubishi’s Xlink Tech Resin System makes sure the maximum carbon fiber content is there for smooth feel without reducing the strength of the shaft. MR70 carbon fiber is used for reinforcing the shaft and boron is used in the tip for its high strength and compression properties.

Finau is still using his trusty Ping G430 LST driver in 9 degrees and has the adjustable hosel set to -1 degree of loft (standard lie angle). Finau’s long-time favorite Lamkin UTX Green grip is installed. He definitely has a few extra wraps of tape under that grip as you can see the bulge down where the grip meets the shaft.

One final note: Per Ping’s PGA Tour rep Kenton Oates, Finau’s driver is also adjusted to play one degree upright to help dial in his desired launch.

We’ll see how he fares with the new setup this week in Houston!

Your Reaction?
  • 10
  • LEGIT1
  • WOW2
  • LOL0
  • IDHT0
  • FLOP0
  • OB0
  • SHANK0

Continue Reading

Whats in the Bag

Zac Blair WITB 2024 (March)

Published

on

Driver: Titleist TSR2 (10 degrees, A1 SureFit setting)
Shaft: Fujikura Ventus TR Red 6 X

3-wood: TaylorMade M5 Rocket 3 (14 degrees)
Shaft: Fujikura Speeder 757 Evolution V1 X

Utility: Titleist U510 (3)
Shaft: Aldila Tour Blue 85 X

Irons: Ping i210 (4-6), Miura MB-001 (7-9)
Shafts: Nippon N.S. Pro Modus3

Wedges: Titleist Vokey Design SM10 (46-10F, 58-08M @57, 60 @61), Vokey Design WedgeWorks (52-M)
Shafts: Nippon N.S. Pro Modus3 Tour 105 X

Putter: Scotty Cameron prototype

Grips: Golf Pride Tour Velvet

Ball: Titleist Pro V1

Your Reaction?
  • 3
  • LEGIT0
  • WOW1
  • LOL0
  • IDHT0
  • FLOP0
  • OB0
  • SHANK0

Continue Reading

Whats in the Bag

Martin Trainer WITB 2024 (March)

Published

on

Driver: Wilson Staff Staff Model (6.5 degrees)
Shaft: Mitsubishi Kai’li Blue 70 TX

3-wood: Wilson Staff WLabs Prototype (13 degrees)
Shaft: Mitsubishi Tensei CK Orange 80 TX

Irons: Wilson Staff Staff Model (2, 4-9)
Shafts: True Temper Dynamic Gold Tour Issue X100

Wedges: Wilson Staff Staff Model (52, 56, 60)
Shafts: True Temper Dynamic Gold Tour Issue X100

Putter: Bobby Grace Greg Chalmers Prototype

Grips: Golf Pride Tour Velvet

Your Reaction?
  • 10
  • LEGIT1
  • WOW1
  • LOL0
  • IDHT0
  • FLOP0
  • OB0
  • SHANK0

Continue Reading

WITB

Facebook

Trending