Posted 27 February 2013 - 09:24 PM
You probably could, as long as tip size is the same, but it's going to look ugly as sin. Unless someone previously installed it as a blind bore, you are going to have atleast a couple inches of tip prep on the shaft if it was done right which means that all the paint will be stripped to raw graphite. You either are gonna have to tip the heck out of it as long as the parallel section is long enough or have an exposed part of the shaft showing. I would just plan on looking to find a new shaft or previous pull that wasn't in a bore thru head to begin with.
Taylormade SLDR 9.5 w/ stiff Speeder 57
Callaway 3 Deep 14.5 w/ PXv 6.0
Stage 2 18.5/21.5 rescue w/ Steelfiber
Bridgestone J40 CB 4-PW w/ Steelfiber
Scratch 53/58 wedges w/ Steelfiber i80
Odyssey Protype 2-Ball