8 replies to this topic

[JaxBeachNole]

I can't figure out how to remove the slim 55.

[swirvn]

I just pulled one last week. I used the same process as any other grip. Used a needle and solvent and injected the grip while twisting and it came right off with no issues. Reinstalled it on another putter as well.

If your in Orange Park, stop by Edwinn Watts on Wells Rd as Rob there can pull them too using  an air compressor.

[Dillio187]

pain in the...unless you installed it using an air compressor and no solvent.

[Ricky Ross]

I use the golfworks v groove remover at work. These are a pain to get off if your reusing it.

[reg1900]

JaxBeachNole, on 22 December 2012 - 07:26 PM, said:

I can't figure out how to remove the slim 55.

I don't think god himself could remove one and save it.

Awful to install, impossible to save. I just take to it with a box cutter.

[BRIDGESTONE1]

hack saw, start at the bottom of the grip, lay the blade against the shaft, and cut the flat side of the entire grip off.. from there you should be able to peel the rest.

[wundej]

reg1900, on 23 December 2012 - 04:17 AM, said:

JaxBeachNole, on 22 December 2012 - 07:26 PM, said:

I can't figure out how to remove the slim 55.

Umm, not really.
I removed a ultra slim and a slim with the golfsmith t handle grip remover. Reinstalled with air. No issues. Depending on how crazy you go, you may stretch them a bit but a wrap or two extra will hold them in place without issue.

I don't think god himself could remove one and save it.

Awful to install, impossible to save. I just take to it with a box cutter.

[joekelli]

try to pop it off with compressed air.

[RookieBlue7]

Yep, if taped a healthy does of solvent with a tool works. So does an air compressor and Solvent. Doesn't take long if you're proficient with tools