Tour AD DI6/7
Posted 24 February 2011 - 06:09 AM
Posted 24 February 2011 - 08:34 AM
Posted 24 February 2011 - 09:34 AM
the 6 yes - the 7 no. i hit the ball very high, tried the DI7 after talking to a few very knowledgeable fitters and a tour rep, and it gets the ball up maybe a degree higher than other shafts then IMMEDIATELY flattens out. someone posted some information that the DI series in a Japanese test of all the 2010 shafts had the LOWEST spin and LOWEST overall total height. i will have to search for it and post it. you are spot on with the 6 though. HIGH launch / LOW spin! high ball hitters stay away!
MID launch is perfect description. Tipping with any shaft is so important. That is why the average hobbyist (such as myself) can try very nice high end shafts and form an opinion that isn't factual. you need a good fitter to properly help you in the process. i can't say that i follow my advise all of the time, but i make sure to only form my opinion if something was PROFESSIONALLY dialed. If i'm not mistaken - aren't you a fitter? PM me sometime and lets chat about the razr hawk tour. wanting some help making a decision...
Nike CT 13* - Motore Speeder 8.2TS
Nike CP 17* hybrid - TOUR AD DI 95x
Nike 2014 Split Cavity 3-PW - PX 6.5
Nike Raw VR Forged 54.12 / 58.10
Nike Oven Proto 003 - SS Ultra Slim 1.0
Posted 24 February 2011 - 10:09 AM
Tour Edge XCG6 11.5° Matrix HD6.1x
Cleveland FL 19° - Miyazaki C.Kua 59s
Miura CB-501 4-PW - Recoil Prototype 95
Scratch 50, 54, 58 - Recoil Prototype 95
Odyssey Black Series Tour Design # 6
Posted 24 February 2011 - 08:24 PM
It felt good, but I guess it is not the real thing.
Posted 24 February 2011 - 09:22 PM
Callaway 3Deep 13* Fuji TS 7.3X
Adams LSP 18* Matrix Altus X
Srixon ZTX II 3-PW C Taper S+
Cleveland 588 Forged 52*/58* DG Spinner+
TaylorMade Ghost Spider S Slant
Posted 24 February 2011 - 10:00 PM
Posted 24 February 2011 - 10:08 PM
Similar. If tipped propperly for the player the RIP 60 will spin slightly less and the DI 7 will spin slightly less. Close though.
Posted 07 March 2011 - 07:17 PM
Posted 07 March 2011 - 11:46 PM
Besides, you can always pull and cut, you can't add tip back on.
Posted 08 March 2011 - 12:16 AM