Lead tape on driver
Posted 15 May 2018 - 01:43 PM
Edited by jbsg02, 15 May 2018 - 01:44 PM.
Posted 15 May 2018 - 02:17 PM
Cobra King LTD 3/4 - Matrix VLCT ST 82 (77g)
TM Jetspeed Hybrid 19* - Matrix Studio 94 (96g)
TM Jetspeed Hybrid 22* - Matrix Ozik HD Program 95 (99g)
Cleveland 588 CB 4-PW - DG S300
Cleveland RTX-3 54*
Cleveland RTX-3 60*
Posted 15 May 2018 - 02:24 PM
And the only way lead tape might help that is if the increased swing weight causes you to slow down the release in your swing. So couldn't hurt to try but yo should really check your impact location first (foot powder spray).
No the lead tape will not lower the c.g. enough to do anything (unless you add so much that the head becomes unplayable due to being way too heavy).
Posted 16 May 2018 - 03:18 AM
Posted 16 May 2018 - 09:14 AM
Posted 16 May 2018 - 09:20 AM
The concept is valid (IF you are getting good center face contact), but the problem is that you are limited with how much change you can accomplish with the lead tape. It's really not a lot. Significant changes of that type really has to come from larger design changes.
Posted 16 May 2018 - 09:26 AM
Titleist 917f2 15° c1
Titleist 816h2 19° b1
Titleist Ap2 716 4-gw
Cleveland rtx3 54,58
Ping sigma g darby
Posted 16 May 2018 - 10:45 AM
Posted 16 May 2018 - 01:52 PM
My swing speed is right around 98. And I am carrying the ball about around 230. Nothing scientific behind ball being too high, other than eye test. But it just seems the ball is going very high, coming down soft and not getting much roll.
Edited by mci711, 16 May 2018 - 01:52 PM.
Posted 16 May 2018 - 06:31 PM
3wood: Tour Edge Exotics EX9 15* Matrix Ozik Red Tie S
3 hybrid: Ping G 19* Alta 70 S
4i: Mizuno JPX 900 Hot Metal C-Taper Lite S
5-GW: Mizuno JPX 900 Forged C-Taper Lite S
Wedges: Cleveland RTX-3 V-MG 54* & 60*
Putter: 2018 Newport 34”
Posted 17 May 2018 - 04:01 AM
Not really. For moving weight, you'd likely have to get up into the 12-15 gm range even for some very small changes. For adding, probably takes more like 20-25 gm.
Edited by Stuart G., 17 May 2018 - 04:02 AM.
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users