Connect with us

Equipment

Forum Thread of the Day: “What’s the most forgiving wedge?”

Published

on

Today’s Forum Thread of the Day comes from lefty74pgh who is in search of a wedge that will offer him the most forgiveness. Our members weigh in with not just club advice, but also general suggestions for those struggling with their consistency from 50 yards and in.

Here are a few posts from the thread, but make sure to check out the entire discussion and have your say at the link below.

  • Lancj1: “I say again if you are buying GI irons, get them down to lob wedge. My ping G400 is far better than the Cleveland’s – I’m sure When I had Callaway XR those were great too. If you aren’t good enough to play specialist wedges, imho stick with the set till you are.”
  • herdman: “I have a CBX for my 50-degree wedge, and then a PM grind 56 and then a Ping Eye Gorge 60. I like that setup. I find them all to be pretty forgiving. But, I like the PM Grind at the 56 because it is very versatile.  Mainly use the CBX for the 90 to 100-yard shot.”
  • dpark: “At a minimum, you should be fit for wedges to figure out what type of sole design is best for you. Obviously, lessons and practice would be better. Depending on if you are “digger” or “sweeper”, the right sole design will help with your mishits.”
  • Mahamilto: “In short: If you want forgiveness at the bottom of the bag, pick a set style wedge for the GW, as most amateurs use this club for full swings more than anything else. For the remaining wedges, you have to pick them based on turf interaction and your style of play/swing. The wedge that gives you the best turf interaction will give you the best accuracy and ease of use. I cannot begin to stress this enough. It took me a while to understand it, but when I did, my wedge game became a weapon instead of a liability.”

Entire Thread: “Most forgiving wedge?”

Your Reaction?
  • 35
  • LEGIT3
  • WOW0
  • LOL3
  • IDHT0
  • FLOP6
  • OB1
  • SHANK40

Gianni is the Managing Editor at GolfWRX. He can be contacted at [email protected].

15 Comments

15 Comments

  1. joro

    Dec 24, 2018 at 6:29 pm

    Every Wedge has its own personality and what is good for one may not be good for others. Depends on how you swing it, a bounce that works, a feel that you like, right weight, right look and feel. So the question is really stupid. But, if you are looking for the most forgiving wedge it would be the Incredible Alien. That thing is so easy that a Monkey could hit it. I had one and was 100% with all shots Wedge, and Sand was a snap as was off cement, out of a puddle, and any other iffy lies I could get into. Even from a rock in a lake, lol.

  2. Brad

    Dec 23, 2018 at 9:04 am

    If you are seeking extra forgiveness in something with as much loft as a wedge – i.e. the easiest club to hit in the bag because loft is your friend – then it is time to spend at least half as much time practicing with your wedges as you do with your driver…

  3. Tom

    Dec 22, 2018 at 5:43 pm

    This guy Gianni doesn’t know ‘Richard’ about golf equipment

  4. Dan

    Dec 22, 2018 at 12:43 am

    If the question is most accurate wedge then your not asking about short game, where accuracy is based on technique. Be definition the best wedge needs to be inaccurate to be versatile on many lies, distances and spin. So if you need accuracy play a game improvement iron down to sw and get a LW in a wedge(Vokey md4 etc) your welcome

  5. Scheiss

    Dec 21, 2018 at 11:40 pm

    EF Grooves. 1025 carbon steel body with Nickel Cobalt played have that never wear out = awesome feel and sharp grooves for ever means reliability and predictability.
    And predictably is what leads to forgiveness because you know what’s going to happen and you learn from it.
    Most of those other edges leave you wondering why something went wrong because they’re unpredictable like that so it leaves you guessing, robbing you of confidence

  6. Tom

    Dec 21, 2018 at 12:36 pm

    Hahahaha…forgiving wedges, are you kidding? there is no such thing!!

  7. lance

    Dec 21, 2018 at 12:30 pm

    The most ‘forgiving’ wedge is not necessarily the ‘best’ wedge… IOW, forgiving and best may be an oxymoron… like most gearheads here… 😀

    • ChipNRun

      Dec 21, 2018 at 3:36 pm

      If wedges beyond PW come with an iron set, the litmus test is usually with the AW or the GW. For the Calla X20 irons, the AW was clunky, real problem with distance control. With the TM SLDR iron, the AW was an excellent club. It blended nicely with a Tour Preferred SW and LW.

      Unless a wedge has a really strange grind, if you like the head you can learn to use it. After all, it’s shaft length is much shorter than a 3i shaft and easier to control.

      Big thing on wedges is the shaft you are using. Let’s say you have:
      * Speed Step 85 (85 grams) in your irons
      * Dynamic Gold wedge flex S300 (129 grams) in your wedges.

      The big weight difference – irons to wedges – may throw off your swing tempo.

      The DG wedge flex is stock shaft in a lot of specialty wedges, so make sure you want a shaft that heavy before ordering.

      • lance

        Dec 21, 2018 at 7:04 pm

        Interesting points on shaft specs for wedges. What do you think about so-called single length irons where the wedges have the same length as a 7 or 8 iron? What shaft specs are needed to make the long shafted wedges effective? Thanks.

  8. Jamie

    Dec 21, 2018 at 11:01 am

    Wrong question. Correct bounce + profile that fits your eye = confidence. Better than the illusion of wedge forgiveness.

    • C

      Dec 21, 2018 at 11:54 am

      Agreed. Wedges aren’t meant to be very forgiving, otherwise they’d all be cavity backed.

      • smz

        Dec 21, 2018 at 1:45 pm

        My PING ZING2 wedges…. P/G/LS/L…. are cavity backed and are tremendously forgiving even when I hit them on the toe… not so much on the heel. I will never change my WITB ZING2s cause they are the ultimate club design.!

        • Caroline

          Dec 23, 2018 at 12:00 am

          Unlike other clubs in your bag wedges have one purpose getting you as close if not in the hole from any where within a 100 yards or so…wedges are played to the hole not just the green so you had better one get the right fit or practice with that wedge until it is the right fit.

        • Tom

          Dec 23, 2018 at 1:37 pm

          If you can’t hit a wedge on the center of the face, you must be a very poor player!

Leave a Reply

Cancel reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Whats in the Bag

Drew Brees WITB 2024 (April)

Published

on

 

View this post on Instagram

 

A post shared by GolfWRX (@golfwrx)

Driver: TaylorMade Stealth 2 Plus (10.5 degrees)

Mini driver: TaylorMade BRNR Mini Copper (13.5 degrees)

5-wood: TaylorMade Stealth Plus (19 degrees)

Irons: TaylorMade P790 (4-8, PW), TaylorMade P760 (9)

Wedges: TaylorMade MG Hi-Toe (52-09, 56-10, 60)

Putter: Scotty Cameron Select Newport 2 Prototype

Check out more in-hand photos of Drew Brees’ clubs here.

Your Reaction?
  • 0
  • LEGIT0
  • WOW0
  • LOL0
  • IDHT0
  • FLOP0
  • OB0
  • SHANK0

Continue Reading

Equipment

Putter Roundup: 2024 Zurich Classic of New Orleans

Published

on

We always get some great photos of some phenomenal putters at tour events and love to share them. Here are a few from the 2024 Zurich Classic that caught our eye and seemed interesting. (And as a reminder, you can check out all our photos from New Orleans here)

MJ Daffue’s Scotty Cameron T-11 Prototype

MJ is going with the new Scotty Cameron T-11 Prototype this week. The putter is a multi-piece mallet that puts an emphasis on stability with the wings on the back. Daffue’s putter does have a design that differs from retail with a monotone finish, which eliminates the black paint on the aluminum parts that we see at retail. He also has a half siteline milled into the top and an L-neck welded on for some additional toe hang. The face features a deeper milling that should offer a softer feel and slightly quieter sound.

Scotty Cameron T-7.5 Prototype

We spotted a few different Scotty Cameron Phantom models with modified rear flanges. It looks like the straight black flange was cut into a half circle for a little softer look at address. On this T-7.5, you can still see the raw aluminum from the back view, so this might have been a last-minute job to get them out on tour. The semi-circle also has a white line on it, maybe to frame the ball differently.

Alex Fitzpatrick’s Bettinardi SS16 DASS

Alex’s SS16 is made from Bettinardi’s famous D.A.S.S., or double-aged stainless steel, for a softer and more responsive feel. The face has a unique diamond pattern milling and features a logo that I feel like I have seen before, but can’t put a name to. The putter is a classic mid-mallet style with a simple, single white siteline on the top. The sole is clean with just the SS16, DASS, and a green triangle logo on it.

Steve Stricker’s Odyssey White Hot No. 2

This putter has made some amazing putts in its long career! Stricker’s White Hot No. 2 might be in the top 10 of most famous putters in golf. When you see all the dents and lead tape, you know the heel will be up and it will be sinking putts! The soft White Hot insert looks to be in good shape and has less wear on it than the rest of the putter. We don’t know how much lead tape is on the sole, but it has to be multiple layers compacted down over the years.

Doug Ghim’s Scotty Cameron T-7 Prototype

This T-7 should win the award for “best color finish” in this list with its deep chromatic bronze. It looks like Scotty added a cherry bomb dot to the heel of the deep-milled face and filled it with a very dark blue paint. The rest of the putter looks pretty stock with its single site line on the topline and twin site lines down the “fangs” of the putter. Twin 5-gram weights are installed in the sole and the putter is finished off with a gloss black double bend shaft with a fill shaft offset.

Your Reaction?
  • 1
  • LEGIT0
  • WOW0
  • LOL0
  • IDHT0
  • FLOP0
  • OB0
  • SHANK0

Continue Reading

Equipment

Spotted: Project X Denali hybrid shaft

Published

on

Project X’s Denali wood shafts have been seen in more and more golf bags this year as we start off the season. As a refresher, Denali Blue is the mid-launch and mid-spin model while Denali Black is for players seeking lower launch and spin.

Denali combines great feel with stability and increased ball speed. Currently, Project X only offers Denali Blue and Black in wood shafts, but we spotted a hybrid shaft in Daniel Berger’s bag at the 2024 Zurich Classic.

The shaft looks to be a Denali Blue 105G – HY in TX flex. No word on details from Project X yet but we can assume that this is a mid-launching shaft that weighs around 105 grams in Tour X-Stiff flex.

Berger has this shaft in his TaylorMade P770 3-iron, likely for some added launch and spin to hold the green from longer distances.

Hopefully, this means we will see some more shafts coming under the Denali name in the future, as I think many of us would like to try one in a hybrid or utility iron!

 

Your Reaction?
  • 0
  • LEGIT0
  • WOW0
  • LOL0
  • IDHT0
  • FLOP0
  • OB0
  • SHANK0

Continue Reading

WITB

Facebook

Trending